RFM offers a full set of custom embedded wireless networking solutions like Zigbee wireless mesh sensor networks, RF modules, IC transceiver, IC transmitters and IC receivers. RFM, Inc. manufactures low power wireless and RF radio modules, wireless mesh nodes for distributed sensing on distributed sensor networks. Low Power radio, n../arrowband and short range devices, front end saw filters, active RFID, RFIC, coupled resonator filters, single silicon chips in the 70MHZ and 300-1000Mhz range.
Modulation: FSK or OOK with frequency hopping
spread spectrum capability
Frequency range: 300 to 510 MHz
High sensitivity: -112 dBm in circuit
High data rate: up to 200 kb/s
Low receiver current: 2.7 mA typical
Low sleep current: 0.1 uA typical
Up to +13 dBm in-circuit transmit power
Operating supply voltage: 2.1 to 3.6 V
Programmable packet start pattern
Integrated RF, PLL, IF and base-band circuitry
Integrated data & clock recovery
Programmable RF output power
Click here if you need additional technical information, to inquire about samples or to discuss your custom needs.
TRC105 is a single chip, multi-channel, low power RF transceiver. It is an
ideal fit for low cost, high volume, two-way short range wireless applications
in the 300 to 510 MHz frequency range. The TRC105 is FCC & ETSI certifiable.
All critical RF and base-band functions are integrated in the TRC105,
minimizing external component count and simplifying and speeding designins.
A microcontroller, RF SAW filter, 12.8 MHz crystal and a few passive
components are all that is needed to create a complete, robust radio function.
The TRC105 incorporates a set of low-power states to reduce current consumption
and extend battery life. The small size with low power consumption
of the TRC105 make it ideal for a wide variety of short range radio applications.
The TRC105 complies with Directive 2002/95/EC (RoHS).
The DR-TRC105 series development kits can be used to evaluate TRC105 radio
technology, and to prototype applications that will use the TRC105 RFIC. These
development kits include the necessary hardware, firmware and utility software to
support efficient TRC105 evaluation and system development.
The DR-TRC105 series evaluation kits include the radio boards, antennas and battery
packs used in the DR-TRC105 series development kits. The evaluation kits can be used
for initial evaluation of TRC105 radio technology and to prototype applications that will
use the TRC105 RFIC.